Course Strip On Siding

What i do is replace them from the bottom up.

Course strip on siding.

Required accessory for starting a vinyl siding job. Measure and cut to length the first piece of siding and nail it in place photo 7. This strip will tip the first piece of siding to the proper angle. It protects the sheathing from rain snow and pests.

Starter strip is used at the bottom of each side of the home to lock the first course of siding in place. Battens are the smaller part that go between the boards. Most manufacturers produce a starter strip that secures the bottom course of siding to the sheathing and holds it at the proper angle. Slide it into the corner and nail it every 16 in.

Subscribe to this old house. Modern board and batten siding refers to the old wood siding that had boards and battens to fill the gaps between the boards. Be sure to center the nails in their slots to. Rip and nail up a 3 8 in.

Staret strip secures the first course of siding to the home. The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. How to stagger lap siding for walls longer than 12 feet you ll need to butt additional lengths of siding together. This should be nailed every 6 inches with it s lower edge running along the chalk line.

Constructed of low maintenance durable vinyl. Backed by ply gem s limited lifetime warranty. Butt joints in adjacent courses should be spaced apart by at least two stud bays for 16 inch o c. Remember that these layout lines represent the top of each siding course.

Cellwood vinyl starter strip is a required accessory to start any vinyl siding installation job. A strip of wood that seals joints in wooden siding. Below the top of the foundation but the lower the vinyl siding is installed the better. Thick treated wood starter strip along the bottom of the wall above the foundation.

Framing or one bay for 24 inch o c. Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. Most suppliers sell two sizes of starter 2 1 2 in. This video shows how to install a starter strip for vinyl and polymer siding installation.

Snap each length of siding in place so that its bottom lip hooks under the starter strip. Spend the extra few bucks on the wider stuff and start your siding a bit lower. Each course except the last one can be nailed normally. The last one that goes between the new work and the old work can be face nailed with hardiplank just nail it off near the edge of the strip above countersink the heads and caulk the nail heads to hide them.