Cutting A Steel Door To Fit

Cutting the top off a steel door depends on one thing.

Cutting a steel door to fit.

Cut metal with your circular saw. Steel used for a door is the same as steel used in any other application. How to cut the top off a steel door. When doors are installed to fit hardwood tile linoleum or any other flat floor covering clearance height from the bottom may be 1 2 inch or.

Always double even triple check your measurements. So generally the best way to cut the door to fit your space is to work with the bottom first. They are not solid metal. Then line up a combination square with the old door s hinge mortises and transfer their locations to the new door marking the edges with a utility knife.

Using a table saw with a fine blade is one method of getting your outside metal door cut to size. Cutting metal clad doors can be done with a metal blade on a circular saw. The type of blade that is chosen. Installing a door may seem like a straightforward process but if the door does not fit precisely into the door frame then a little extra work may be involved.

Trimming the door may require reducing the door s width a job you can do yourself and therefore save the money it would take to hire a professional. Thick using a ferrous metal cutting blade. Following your door s instructions use a pencil and a straight edge to lay out all of the cut lines on the door. The easiest way to do do this if the old door was a good fit is to lay the new door on top of the old door so the edges are flush.

Hot metal chips will fly. So make sure you re accurate and take your time. It may not be an obvious choice but fitted with the right blade a circular saw is a great metal cutting tool. The interior of the door is made up of solid wood framing with fillers and some void space.

Mark out your hinges on the door. The best ways to shorten a door after laying carpet. The exterior metal cladding typically is only 1 16 inch thick. You can cut mild steel up to about 3 8 in.